Tuesday, June 14, 2011

How to remove and install blend door actuator on Dodge Durango 4WD

NOTE
The blend door actuator cannot be adjusted or repaired and, if damaged or faulty, must be replaced. After installation the new actuator must be calibrated using a scan tool.

  1. Disconnect and isolate the negative battery cable.
  2. Remove the instrument panel assembly.
  3. Remove the screws that secure the blend door actuator to the top of the HVAC housing.
  4. Disconnect the HVAC wire harness connector from the blend door actuator.
  5. Remove the blend door actuator from the HVAC housing.

    Click image to see an enlarged view

    Fig. Blend door actuator-front


To install:

  1. Position the blend door actuator onto the top of the HVAC housing. If necessary, rotate the actuator slightly to align the splines on the actuator output shaft with those on the blend-air door linkage.
  2. Install the screws that secure the blend door actuator to the HVAC housing. Tighten the screws to 2 Nm (17 inch lbs.).
  3. Connect the HVAC wire harness connector to the blend door actuator.
  4. Install the instrument panel assembly.
  5. Reconnect the negative battery cable.
  6. Calibrate actuator function using a scan tool.

----------------------

To Order car parts online:--To get heavy discount on car parts .Click this link below:----

http://technoanswers.blogspot.com/2011/05/from-where-to-order-car-parts-online.html

For car error code diagnosis click the link below:---

http://www.automd.com/diagnose/?amdcid=apwldrbrd1

Car no start:--

http://technoanswers.blogspot.com/2011/05/car-will-turn-over-but-will-not-start.html

1 comment:

  1. http://technoanswers.blogspot.com/2011/05/from-where-to-order-car-parts-online.html ... cleafvacuum.blogspot.com

    ReplyDelete