Thursday, July 21, 2011

How to Replace a Head Gasket

See Figures 1 through 10

Drain the engine cooling system.


To access and remove the cylinder head, the engine must be lowered and the both motor mounts removed.

1.) Remove the left and right engine access hole covers.

2.) Remove the motor mount bolts and nuts. (See Fig.1-3 Below)


1
7707Photo may not be specific to your vehicle

Loosen and remove the upper mount nut (above)

2
7708Photo may not be specific to your vehicle

Next remove the motor mount lower retaining nut and bolt (above)

3.) Raise the engine and remove the motor mounts.

3
7709Photo may not be specific to your vehicle

Slide the mount out from between the members (above)

4.) Slowly lower the engine being careful not to rest the engine weight on the oil filter housing.SAFETY NOTE: Place a block of wood where the motor mounts had been to support the engine.

5.) Remove the exhaust manifold .

6.) Remove the distributor.

7.) Disconnect the EGR pipe bracket-to-intake manifold bolt. NOTE:This bolt can be reached from the right hand access hole. Follow the EGR pipe from the cylinder head back until you find the bracket and bolt.

8.) Remove the nut and bolt holding the EGR pipe to the cylinder head.

9.) Disconnect the engine wiring harness and fuel connections for the cylinder head.

10.) Remove the fuel rail with injectors.

11.) Unbolt and disconnect the two cylinder head and water neck brackets from the forward end of the head.

12.) Remove the lower intake manifold support bracket.

13.) From the left engine access hole, remove the two upper intake manifold bracket bolts.

14.) Remove the intake manifold-to-cylinder head hardware, then break the manifold free from the head.

15.) Remove the water neck mounting bolts and loosen the water neck from the cylinder head.

16.) Remove the spark plug cover, plug wires, and valve cover.

17.) Remove the camshafts. Refer to the Camshaft Removal and Installation procedure in this section.

18.) Place a jack under the cylinder head with a block of wood between them. Remove the cylinder head bolts.
NOTE: Make sure you remove the two front bolts first in the timing chain area.

19.) Remove the two bolts in front of the head before the other head bolts are removed. The two bolts are located in front of the timing chain.

20.) Uniformly remove the head bolts following the sequence.

NOTE: The cylinder head is positioned on the engine sideways and is very heavy. Be careful not to drop the head during removal. It is advised to have an assistant ready to help.

21.) Pull the cylinder head from the dowels on the cylinder block.

22.) Remove the cylinder head gasket.

4
7710Photo may not be specific to your vehicle

Cylinder head bolt loosing sequence (above)

To install:

NOTE: Always clean and inspect the cylinder head and mating surface for cracks and flatness when removed.

1.) Clean the gasket mating surfaces and check for warpage.

2.) Apply seal packing to two locations on the cylinder block as shown.

5
7711Photo may not be specific to your vehicle

Apply seal packing in these two areas on the block (above)

3.) Install the head gasket and cylinder head.

6
7712Photo may not be specific to your vehicle

Place the head gasket in the correct position on the block (above)

4.) (If the camshaft timing gear was removed), align the matchmarks placed on the timing gear and chain during removal.

5.) Place the cylinder head in position on the gasket.

6.) Oil the bolts and using the proper sequence, tighten the bolts in 3 steps.

7.) Uniformly tighten the head bolts to 29 ft. lbs. (39 Nm).

8.) Mark the front of the cylinder head bolt with paint.

9.) Retighten the cylinder head bolts 90 degrees in the numerical order as shown.

NOTE: Check that the painted mark is now facing sideward.

10.) Retighten the cylinder head bolts an additional 90 degrees.

NOTE: Check that the painted mark is now facing rearward.

7
7713Photo may not be specific to your vehicle

Tightening specifications can be found on a label located on the No. 2 cylinder head cover (above)


8
7714Photo may not be specific to your vehicle

Cylinder head bolt tightening sequence (above)


9
7715Photo may not be specific to your vehicle

Mark the front of the head bolt with paint (above)


10
7716Photo may not be specific to your vehicle

Retighten the head bolts 90 degrees in the order shown (above)

11.) Install and tighten the 2 front mounting bolts to 15 ft. lbs. (21 Nm).

12.) Install the camshafts.

13.) Install all remaining components.

14.) Fill the cooling system and fill the engine with oil.

15.) Connect the battery cable, start the engine, and check for leaks.

16.) Road test the vehicle for proper operation and recheck all fluid levels.

----------------------

For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.

---------

The car will not start?

http://schematicsdiagram.blogspot.com/2011/06/car-will-not-start.html

-----------------

Car will not crank?

http://schematicsdiagram.blogspot.com/2011/06/car-will-not-crank.html

-----------

Car has no spark?

http://schematicsdiagram.blogspot.com/2011/06/car-has-no-spark.html

-------------

How to troubleshoot car battery?

http://schematicsdiagram.blogspot.com/2011/06/how-to-troubleshoot-car-battery.html

-----------------

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

How to replace starter in car?

http://schematicsdiagram.blogspot.com/2011/06/how-to-replace-starter-in-car.html

-----------

car will turn over but will not start?

http://technoanswers.blogspot.com/2011/05/car-will-turn-over-but-will-not-start.html

-----------------

The Brake Indicator Light Stays On dash of car?

http://schematicsdiagram.blogspot.com/2011/06/brake-indicator-light-stays-on-dash-of.html

The ABS and Traction Control Lights stays ON dash of car?

http://schematicsdiagram.blogspot.com/2011/06/abs-and-traction-control-lights-stays.html

Check Engine Light On car?

http://schematicsdiagram.blogspot.com/2011/06/check-engine-light-on-car.html

-------------------------

How to replace Interior Lights on car?

http://schematicsdiagram.blogspot.com/2011/06/how-to-replace-interior-lights-on-car.html

Car lights not working, even after replacing the bulb/lamp?

Click this link below:--

http://schematicsdiagram.blogspot.com/2011/06/car-lights-not-working-even-after.html

---------------

How to replace head lights on car?

http://schematicsdiagram.blogspot.com/2011/06/how-to-replace-head-lights-on-car.html

--------------------

How to replace Parking, turn, and Brake Lights on car?

http://schematicsdiagram.blogspot.com/2011/06/how-to-replace-parking-turn-and-brake.html
How to remove the door panel on car?

http://schematicsdiagram.blogspot.com/2011/06/how-to-remove-door-panel-on-car.html

How to replace power window motor in car?

http://schematicsdiagram.blogspot.com/2011/06/how-to-replace-power-window-motor-in.html

How to test relays on car?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-relays-on-car.html

-----------------------------

How to troubleshoot Engine Misfires?

http://schematicsdiagram.blogspot.com/2011/06/how-to-troubleshoot-engine-misfires.html

------------

The spark plug firing order for car?

http://schematicsdiagram.blogspot.com/2011/06/spark-plug-firing-order-for-car.html

------------------------

Where is the Thermostat located in car?

http://schematicsdiagram.blogspot.com/2011/06/where-is-thermostat-located-in-car.html

How to recharge AC on Auto/Truck/car?

http://schematicsdiagram.blogspot.com/2011/06/how-to-recharge-ac-on-autotruckcar.html

-------------------

How to trouble shoot speedometer?

http://schematicsdiagram.blogspot.com/2011/06/speedometer-not-working.html

To Order car parts online:--To get heavy discount on car parts .Click this link below:----

http://technoanswers.blogspot.com/2011/05/from-where-to-order-car-parts-online.html

How to Replace Coil Springs?

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-coil-springs.html

How to Replace an Oil Pan Gasket?

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-oil-pan-gasket.html

How to Replace a Fuel Injector

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-fuel-injector.html

How to Replace a C.O.P. Type Ignition Coil?

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-cop-type-ignition-coil.html

How to Replace a Fuel Pressure Regulator?

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-fuel-pressure-regulator.html

How to Replace a Fuel Pump?

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-fuel-pump.html

How to Replace a Rear Lift Gate Locking Mechanism?

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-rear-lift-gate-locking.html

How to Clean a Fuel System

http://schematicsdiagram.blogspot.com/2011/07/how-to-clean-fuel-system.html

How to Replace an Ignition Coil

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-ignition-coil.html

How to Replace a Windshield

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-windshield.html

How to Replace a Mass Air Flow Sensor

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-mass-air-flow-sensor.html

How to Replace a Rear Distance Sensor

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-rear-distance-sensor.html

How to Replace a Muffler

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-muffler.html

How to Replace an Engine

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-engine.html

How to Replace an Intake Manifold Gasket

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-intake-manifold-gasket.html

How to Replace an Oil Pump

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-oil-pump.html

How to Lubricate a Brake Pedal Linkage ?

http://schematicsdiagram.blogspot.com/2011/07/how-to-lubricate-brake-pedal-linkage.html

How to Replace a Windshield Wiper Motor

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-windshield-wiper-motor.html

How to Replace a Distributor Cap

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-distributor-cap.html

How to Replace a Door Weather Stripping

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-door-weather-stripping.html

How to Replace a Freeze Plug

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-freeze-plug.html


How to Replace a Heater Core

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-heater-core.html

1 comment: