Monday, December 5, 2011

2008 Ford Ranger Shifter Knob Removal?

If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.

The details to remove Shifter knob is as follows :----
On some cases the knob head is threaded,you can spin the knob in anti-clock wise direction.But if it looks like one unit and not a threaded knob then the possible chances are there that the shift knob is glued and pressed on, the best way to remove it intact is to heat the knob with a heat gun and pull straight up with a lot of force, please be very careful because when the knob finally releases there is very good chance that you can hit yourself in the face, if the knob is not to be used again you cut the knob-side with a dremal tool.Available at hardware stores or auto part stores.

This details will help.Thanks.
For more car problem troubleshooting solutions,check the list mentioned below :----

Car takes time to Crank and start?

Car jerks while going uphill and Check engine light is ON?

Car turns over, but only starts, if starter is jumped?

Service Engine Soon light stays on?

Gasoline around gas cap?

Car will not run after resetting inertia switch on Mercury Mystique?

VAN emits whitish bluish smoke and bad fuel smell from exhaust

Car cigarette lighter fuse blows out?


Car will not go into 4WD high or 4WD low?

Truck is hard to start and Emits smoke while starting?

Engine cuts out at 3000 RPM?

Car turns over but will not start, only makes clicking sound?

Catalytic Converter glowing hot?

After getting car washed, check engine light is ON and key less entry not working, tried reprogramming. Also car shows fuel pressure?

Fuel gauge jumps from empty to full?

Why airbag light flashes 7 times?

Passenger side Folding Mirror is not operating?

Very low air output on Chevrolet Trailblazer?

After replacing battery, ignition not working?

Where is Fuse box located on 2002 Honda Accord?


How to reset Radio code after car battery is died?

Car still runs Rough after tune up?

Car cranks, has spark but will not start?

Cylinder 6 Misfire?

Chevy s-10 blazer 4.3l Spark Plug Firing Order?

No comments:

Post a Comment