Friday, December 2, 2011

Car will not go into 4WD high or 4WD low?

If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.

Many car users notice this same problem.Mostly the 4wd indicator comes on dash,when it goes in 4WD high or low.
This light is turned on by the tranfercase control module.If the light is not on and you can't activate 4 high or 4 low then check the fuses first.If the fuses are good, get under the truck and tap on the transfer case motor while some pushes the 4 high button.If you dont hear any clicking from the motor then most likely the module is bad.And it has to be inspected and replaced.-------------
This basic details will help.Thanks.
-----------
For more car problems and solutions, check the list mentioned below:-----



Car jerks while going uphill and Check engine light is ON?


Car turns over, but only starts, if starter is jumped?


Service Engine Soon light stays on?


Gasoline around gas cap?


Car will not run after resetting inertia switch on Mercury Mystique?

VAN emits whitish bluish smoke and bad fuel smell from exhaust

Car cigarette lighter fuse blows out?

CD MECH ERROR?



No comments:

Post a Comment