Thursday, December 1, 2011

How to remove ignition switch on VW Car models?


If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.

To remove ignition switch,first the ignition lock cylinder has to be removed out.

The detailed procedure is as follows :----
1995-99 Cabrio, 1993-99 Golf and Jetta


    Disconnect the negative battery cable.Center the steering wheel.Remove the air bag.Remove the steering column switches.If the vehicle is equipped with an automatic transmission, detach the shift lock cable from the lock cylinder housing.Remove the adapter sleeve from the steering column.Remove the spring and horn contact ring from the steering column assembly.Detach the sheer bolt.Insert the ignition key and unlock the cylinder, then detach the wiring connectors.Once all wiring has been detached, slide the housing off the steering column.Mark and drill the lock cylinder as shown and described in the above procedure.Compress the stop spring and pull the lock cylinder out of the steering column housing.Put the new lock cylinder into the steering lock housing.Insert the key into the lock cylinder.While you gently turn the key, insert the lock cylinder fully into the housing.The rest of the installation procedure is the reverse of removal. This details will help. Thanks,
  1. --------------
  2. For more ignition related problems and solutions,check the list mentioned below :----
  3. How to replace Ignition Lock Cylinder on Acura Car Models?


    How to replace Ignition Switch on Acura Car Models?


    How to test and replace Ignition coil on Audi A4 Car models?


    How to test and replace Ignition Control Unit on Audi A4 Car models?


    How to test and replace Ignition Coil Pack on Audi A4 Car models?


    How to Replace a C.O.P. Type Ignition Coil?

    How to Replace an Ignition Coil

    How to Replace an Ignition Control Unit


    How to Replace an Ignition Wire Set

    http://schematicsdiagram.blogspot.com/2011/08/how-to-replace-ignition-wire-set.html





No comments:

Post a Comment