Thursday, December 8, 2011

How to Replace Ignition Switch on Chevrolet Caprice Classic?

Its not that hard,you can easily replace the ignition switch.
Your ignition switch is mounted to the steering column just below the knee bolster by 2 5/16in bolts. First remove the 2 connectors from the switch, then the bolts. The actuating rod is slid into the side of the switch and extends up the column to the lever of the key barrel. Carefully pull the rod from the side of the switch. Slide the actuating rod into the new switch and bolt it on, then plug in the connectors.
This details will help.Thanks.
---------------
If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.


For more ignitions related problems and solutions, check the list mentioned below: ----

How to replace Ignition Lock Cylinder on Acura Car Models?

How to replace Ignition Switch on Acura Car Models?

How to test and replace Ignition coil on Audi A4 Car models?

How to test and replace Ignition Control Unit on Audi A4 Car models?

How to test and replace Ignition Coil Pack on Audi A4 Car models?

How to Replace a C.O.P. Type Ignition Coil?

How to Replace an Ignition Coil

How to Replace an Ignition Control Unit

How to Replace an Ignition Wire Set


No comments:

Post a Comment