Thursday, December 15, 2011

How to replace Oil Pan on 2008 Honda Odyssey?

Replacing Honda Odyssey Oil pan details are as follows :----

Oil Pan  

Removal & Installation


  1. Raise the vehicle on a hoist to full height.
  2. Drain the engine oil.
  3. Remove the splash shield.
  4. Remove exhaust pipe A.
  5. 2008 J35A7 Engines: Remove the Crankshaft Position (CKP) sensor cover and electrical connector.
  6. Remove the torque converter cover (A) and the two bolts (B) securing the transmission.

    Click image to see an enlarged view
    Fig. Remove the torque converter cover (A) and the two bolts (B) securing the transmission
  7. Remove the bolts securing the oil pan.

    Click image to see an enlarged view
    Fig. Using a flat blade screwdriver, separate the oil pan from the block in the places shown
  8. Using a flat blade screwdriver, separate the oil pan from the block in the places shown.
  9. Remove the oil pan.
To install:
  1. Remove all of the old liquid gasket from the oil pan mating surfaces, bolts, and bolt holes.
  2. Clean and dry the oil pan mating surfaces.
  3. Apply liquid gasket, P/N 08717-0004, 08718-0001, 08718-0002, 08718-0003, or 08718-009, evenly to the oil pan mating surface of the engine block.
    NOTE
    Do not install components if too much time has passed after applying the liquid gasket (for P/N 08718-0002, no more than 4 minutes, for all others, no more than 5 minutes). Instead, remove the old residue and reapply liquid gasket.



    Click image to see an enlarged view
    Fig. Apply liquid gasket to the inner threads of the bolt holes and the engine block along the area indicated by the broken line
  4. Install the oil pan on the engine block.

    Click image to see an enlarged view
    Fig. Oil pan bolt tightening sequence
  5. Tighten the bolts in two or three steps. In the final step, tighten all bolts, in sequence, to 12 Nm (104 inch lbs.).
    NOTE
    After assembly, wait at least 30 minutes before filling the engine with oil.

This details will help you.
----------
If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.

------------
For your help, there are few Car Engine oil related solved problem listed below. You can go through it.

Low oil pressure light on Dodge Magnum? 
http://howtobyme.blogspot.com/2011/11/low-oil-pressure-light-on-dodge-magnum.html 

Kia Sportage leaking oil from oil pan? 
http://howtobyme.blogspot.com/2011/11/kia-sportage-leaking-oil-from-oil-pan.html 
Car Turns OFF due to low oil pressure warning light?


For more oil and oil pump details check out the direct links below: --- 
Oil pressure for 2001 gmc jimmy V6? 


No comments:

Post a Comment