Wednesday, February 22, 2012

How to remove Rear Adjustable Arm on 2007 Toyota Camry?

The rear adjustable arm is on passenger side.Its also called as dent right rear lateral arm.
To do this remove the bolts attached to the outer points.

The bolt and nut on the outer attaching point is straight forward to remove unless you live in the rust belt in the NE. The inside body attachment becomes the problem. The nut is welded to the cross member and will not need held. The bolt comes out. The problem is there is very little clearance to get the bolt to clear the body. Some guys bend the tin bracket slightly to get the bolt to clear. Then others just loosen the 4 bolts and the 2 nuts that are by the sway bar bushing mounts just enough to lower the cross member so the bolts clear the body. You only need about an inch.

This will help.
Thanks.

See below latest solved car problems :----

How to replace Drive Shaft bearing on Toyota pick up?

http://schematicsdiagram.blogspot.in/2012/02/how-to-replace-drive-shaft-bearing-on.html

Car suddenly died and won’t start?

http://technoanswers.blogspot.in/2012/02/car-suddenly-died-and-wont-start.html

Car is starting but not turning over?

http://technoanswers.blogspot.in/2012/02/car-is-starting-but-not-turning-over.html

Engine cranks but will not start?

http://technoanswers.blogspot.in/2012/02/engine-cranks-but-will-not-start.html

Exclamation indicator light on ford freestar dash?

http://technoanswers.blogspot.in/2012/02/exclamation-indicator-light-on-ford.html

2004 ford freestar van idles rough?

How to remove Intake Manifold Tuning Valve?

http://technoanswers.blogspot.com/2012/01/how-to-remove-intake-manifold-tuning.html

Trunk release Problem on Toyota Camry?

http://schematicsdiagram.blogspot.in/2012/02/trunk-release-problem-on-toyota-camry.html

CMFI details for GMC vehicles?

http://technoanswers.blogspot.com/2012/01/cmfi-details-for-gmc-vehicles.html

Mazda MPV cranks but will not start?

http://technoanswers.blogspot.com/2012/01/mazda-mpv-cranks-but-will-not-start.html

MAZDA MPV WILL CRANK BUT NOT TURN OVER TO START?

http://technoanswers.blogspot.com/2012/01/mazda-mpv-will-crank-but-not-turn-over.html

Freightliner fl112 fuse box diagram?

http://technoanswers.blogspot.com/2012/01/freightliner-fl112-fuse-box-diagram.html

Car will not turn the ignition to start?

http://technoanswers.blogspot.com/2012/01/car-will-not-turn-ignition-to-start.html

Car only starts when gas pedal is pressed?

http://technoanswers.blogspot.com/2012/01/car-only-starts-when-gas-pedal-is.html

How to compare pattern of left bank and right bank sensors?

http://schematicsdiagram.blogspot.in/2012/02/how-to-compare-pattern-of-left-bank-and.html

Hyundai coupe f2 hazard fault?

http://schematicsdiagram.blogspot.com/2012/01/hyundai-coupe-f2-hazard-fault.html

Gas door hinges broken on Toyota?

http://technoanswers.blogspot.in/2012/02/gas-door-hinges-broken-on-toyota.html

Where is the bulb located in glove box?

http://repairhelpcenter.blogspot.com/2012/01/where-is-bulb-located-in-glove-box.html

Additional wiring harness needs to be installed in a brake controller for electric brakes on 2012 Toyota Highlander?

http://repairhelpcenter.blogspot.com/2012/01/additional-wiring-harness-needs-to-be.html

Fail smog test due to gas filter hose?

http://repairhelpcenter.blogspot.com/2012/01/fail-smog-test-due-to-gas-filter-hose.html

Clutch squeaking under hood?

http://repairhelpcenter.blogspot.com/2012/01/clutch-squeaking-under-hood.html


No comments:

Post a Comment