Thursday, March 29, 2012

Bleeding The Brake System Without Vsc on Toyota Tundra?

Normal brake system bleeding on Toyota.How to bleed Toyota brake system without VSC.

Without VSC
BRAKE LINES Bleeding &
MASTER CYLINDER Lines bleeding procedure is as follows :------


Brake Lines


  1. Connect the vinyl tube to the bleeder plug.
  2. Depress the brake pedal several times, then loosen the bleeder plug with the pedal held down.
  3. At the point where the fluid stops coming out, tighten the bleeder plug, then release the brake pedal.
  4. Repeat until all the air in the fluid has been bled out.
  5. Repeat the above procedure to bleed the air out of the brake line for each wheel.
  6. Check the fluid level and add fluid if necessary.

Master Cylinder




NOTE
Immediately wash off any brake fluid that comes into contact with any painted surfaces.


NOTE
Depressing the brake pedal with the reservoir cap removed will cause the fluid to spray.


NOTE
When bleeding, maintain the amount of fluid in the reservoir between the Min. and Max. lines.
  1. Fill reservoir with dot3 brake fluid.
  2. Using SST 09023-00101, disconnect the brake lines from the master cylinder.
  3. Slowly depress the brake pedal and hold it there.
  4. Block the outer holes with your fingers, and release the brake pedal.
  5. Repeat 3 or 4 times.

These details will help.
Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html



No comments:

Post a Comment