Thursday, March 29, 2012

Brake Disc Rotor replacing on Toyota Tundra?

The details are to replace Front disc Brake rotor.The Toyota Tundra brake disc rotor removal procedure is as follows :-----


Brake Disc (Rotor)
REMOVAL & INSTALLATION Step By Step details are as follows:-----


  1. Raise and support the vehicle safely.
  2. Remove the tire and wheel assembly.
  3. Disconnect the brake hose from the caliper. Plug the end of the hose to prevent loss of fluid.
  4. Remove the bolts that attach the caliper to the torque plate.
  5. Lift the bottom of the caliper up and remove the caliper assembly.
  6. Remove the brake rotor.
To install:
  1. Install the brake rotor.
  2. Grease the caliper slides and bolts with lithium grease or equivalent. Install the caliper and secure with the bolts. Torque the bolts to 90 ft. lbs. (123 Nm).
  3. Connect the brake hose to the caliper. Torque 11 ft. lbs. (15 Nm).
  4. Fill the brake system to the proper level and bleed the brake system.
  5. Install the tire and wheel assembly.
  6. Top off the brake fluid level in the master cylinder. Check for leaks and proper brake operation.
  7. Connect the negative battery cable to the battery. 

    image
    Fig. Front disc brake and related components-2001-2003


    Click image to see an enlarged view
    Fig. Front disc brake and related components-2004-2006
These details will help.
Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html


No comments:

Post a Comment