Friday, March 2, 2012

Brake pedal travels excessively?

This problem is noticed many a times.
The brake pedal travels excessively when brakes are applied.
This problem is called.
Excessive Brake Pedal Travel.

This problems occurs due to many possibilities.

The details below will help you.

A worn brake linings front or rear (or both), misadjusted drum brakes, or air in the brake lines.Can cause such problems.


  •  Inspect Brake Pad/Shoe-Front and rear both:   Worn or Damaged Brake Pad/Shoes can cause this problem.
  •  Inspect Brake line:  If  Pressure Air in Hydraulic System or Fluid Loss is noticed then brake line has to bleed.
  • Inspect Master Cylinder (For Brake System): Faulty Brake Master Cylinder can cause such problems.
  • Inspect Brake Caliper:  Air in Hydraulic System or Fluid Loss can also cause such problems.
  • Inspect Brake Drum :  Excessively Worn Brake Drum can be one reason for this problem.
  • Inspect Wheel Bearing-Front and Rear:   Incorrectly Tightened or Installed Wheel Bearing can cause this excessive brake pedal travel problem.

In some cases this problem is noticed after changing the master cylinder and bleeding the brakes.


AT our garage one of out regular client noticed this same problem on is Light duty ford truck.

I suggest you to go through this detail to understand this problem.

A common problem is the rear wheel anti lock brake valve,they by pass internally and give you a a low, sinking pedal.
The valve is located in the rearbrake line circuit. 

Symptom/Problem: Brake pedal fade, low pedal. The problem is an internal leak in RABS valve.
Background: A common complaint on Ford light duty trucks with the rear anti-lock brake system is that the brake pedal will fade while under steady pressure. In a conventional brake system this would point to an external fluid leak or an internal leak (bypass) in the master cylinder. Generally, one and usually two master cylinders have been replaced already, leaving one very frustrated technician. In this system there is one other possibility - the rear anti-lock brake valve. This valve is the electro-hydraulic proportioning valve located on the left-hand frame rail between the master cylinder and the rear brakes. This valve controls the brake fluid during an anti-lock stop by restricting or bleeding off rear wheel cylinder pressure.
To better understand what's happening, let's take a quick look at system operation. The RABS module continuously monitors rear wheel speed by means of a sensor installed in the rear differential. When the sensor signal to the module shows a rapid decrease in speed - indicating rear wheel lockup will occur - it energizes the isolation solenoid in the RABS valve. By doing this, the normally open valve is now closed, blocking off the line to prevent further brake fluid from entering the rear wheel cylinders. If there is still too great a decrease in rear wheel speed, the module will then energize the dump solenoid in the RABS valve. This solenoid is normally closed and, when energized, will open a port to the accumulator and bleed off some of the pressure to prevent lockup. This fluid is then stored until normal brake functions are resumed and the fluid is returned to the master cylinder.
If rear wheel speed is now OK, the module de-energizes these solenoids to resume normal braking. If speed decreases too rapidly again, it resumes anti-lock control. The module will alternate between the two solenoids and normal braking until there is no further chance of locking up or vehicle speed is now under 5 mph.
The focus is on this dump portion of the RABS valve. Occasionally the seat between the solenoid and the accumulator will leak, causing the pedal to fade during normal pedal applications. This sinking pedal has no other abnormal braking characteristics and is usually not noticed (depending on severity) unless it sits for an extended amount of time with constant pressure applied. It may be due to physical damage or a buildup of contaminants in the hydraulic system, but the results are the same.
Some customers report that the brakes were just fine until a hydraulic component was replaced or repaired and the brakes were bled. Then the pedal started fading. Quite possibly this is due to a new problem that is created by "moving" some of the contaminated fluid into the valve. To diagnose this system, like all brake systems, first verify that there are no external fluid leaks. If visual inspection is OK, disconnect the brake lines at the master cylinder and plug the outlets in the cylinder. When the master cylinder is plugged, if a fade is still experienced, the master is at fault.
If, however, there is no fade, determine if it is coming from the front or rear brakes by blocking one port at a time at the master cylinder. If there is no longer a fading pedal when blocking the port to the rear line, go one step further and build a short brake line to splice between the inlet and outlet lines at the RABS valve to temporarily bypass the valve.
After bleeding the rear brakes and verifying there is a solid pedal, it's a good bet that the problem is in the valve itself. The next step is to replace and bleed the valve (if equipped with a bleeder) and the rear wheel cylinders. Verify the repair and road test.

See below diagram shown below :----

graphic

This details will help you.

Thanks.

See below latest solved car problems :-----

Brake pedal stuck?

http://howtobyme.blogspot.in/2012/03/brake-pedal-stuck.html

After replacing brake rotors and pads, brake pedal remains on floor?

http://technoanswers.blogspot.in/2012/02/after-replacing-brake-rotors-and-pads.html

How to replace Brake Power Booster?

http://repairhelpcenter.blogspot.in/2012/02/how-to-replace-brake-power-booster.html

1997 Chevy Tahoe Brake lights not working?

http://technoanswers.blogspot.in/2012/02/1997-chevy-tahoe-brake-lights-not.html

How to service Drum brakes?

http://repairhelpcenter.blogspot.in/2012/02/how-to-service-drum-brakes.html

What type of problems usually noticed on Drum brakes?

http://repairhelpcenter.blogspot.in/2012/02/what-type-of-problems-usually-noticed.html

How to test Drum Brakes?

http://repairhelpcenter.blogspot.in/2012/02/how-to-test-drum-brakes.html

Brake Bleeder Screw Function?

http://repairhelpcenter.blogspot.in/2012/02/brake-bleeder-screw-function.html

Replacing ABS unit on Buick Century?

http://technoanswers.blogspot.in/2012/02/replacing-abs-unit-on-buick-century.html

How to Deactivate Airbag system on Ford Ranger?

http://technoanswers.blogspot.in/2012/02/how-to-deactivate-airbag-system-on-ford.html

Brake pedal is pulsating and vibrating?

http://repairhelpcenter.blogspot.com/2012/01/brake-pedal-is-pulsating-and-vibrating.html

All types of brake problems and repairs

http://howtobyme.blogspot.com/2011/11/abs-and-service-light-comes-on.html

What is Brake Drum Bar?

http://repairhelpcenter.blogspot.in/2012/02/what-is-brake-drum-bar.html 

ABS light stays on but brakes work fine?

http://howtobyme.blogspot.com/2011/11/abs-light-stays-on-but-brakes-work-fine.html

VCS maintenance required on Toyota Camry?

http://howtobyme.blogspot.com/2011/11/vcs-maintaince-required-on-toyota-camry.html

VCS and ABS lights go on and off intermittently on Lexus?

http://howtobyme.blogspot.com/2011/11/vcs-and-abs-lights-go-on-and-off.html

ABS & Brake lights warning indicator steady on dash and speedometer not working for Dodge Ram?

http://howtobyme.blogspot.com/2011/11/abs-brake-lights-warning-indicator.html

Isuzu rodeo speedometer is jumping?

http://schematicsdiagram.blogspot.com/2012/01/isuzu-rodeo-speedometer-is-jumping.html

E-brake is stuck down on Ford Focus?

http://schematicsdiagram.blogspot.com/2011/12/e-brake-is-stuck-down-on-ford-focus.html

Brake warning light comes on and car will not start intermittently?

http://repairhelpcenter.blogspot.com/2011/12/brake-warning-light-comes-on-and-car.html

When the car stops, abs pump turns ON?

http://howtobyme.blogspot.com/2011/12/when-car-stopsabs-pump-turns-on.html

Where is Power Brake Booster located on 1995 Lincoln Town Car?

http://howtobyme.blogspot.com/2011/12/where-is-power-brake-booster-located-on.html

Sometimes ABS light comes on while Driving?

                     

http://howtobyme.blogspot.com/2011/12/sometimes-abs-light-comes-on-while.html

How Anti-Lock Brakes Work?


Brake System Troubleshooting?

http://technoanswers.blogspot.com/2011/11/brake-system-troubleshooting.html

Car Brake lines have no pressure?

http://schematicsdiagram.blogspot.com/2011/12/car-brake-lines-have-no-pressure.html

Car Brakes Dragging?

http://repairhelpcenter.blogspot.com/2011/12/car-brakes-dragging.html

Car Brakes grabbing?

http://repairhelpcenter.blogspot.com/2011/12/car-brakes-grabbing.html

Car Brakes Making Noise?

http://repairhelpcenter.blogspot.com/2011/12/car-brakes-making-noise.html

Car Brakes Pulling?

http://repairhelpcenter.blogspot.com/2011/12/car-brakes-pulling.html

Pulsating Brake Pedal?

http://repairhelpcenter.blogspot.com/2011/12/pulsating-brake-pedal.html

Spongy brake pedal?

http://repairhelpcenter.blogspot.com/2011/12/spongy-brake-pedal.html

Hard Brake Pedal?

http://repairhelpcenter.blogspot.com/2011/12/hard-brake-pedal.html

How to Disconnect Power to EBCM on Pontiac Grand Prix?

http://schematicsdiagram.blogspot.com/2011/12/how-to-disconnect-power-to-ebcm-on.html

Where is ABS/TCS module located on 2005 Cadillac Deville

http://schematicsdiagram.blogspot.com/2011/12/where-is-abstcs-module-located-on-2005.html

How to Replace Power Brake Booster on 1996 GMC Jimmy?

http://schematicsdiagram.blogspot.com/2011/12/how-to-replace-power-brake-booster-on.html

Isuzu Trooper Shifts hard and Engine Revving in stop?

http://schematicsdiagram.blogspot.com/2011/12/isuzu-trooper-shifts-hard-and-engine.html

What is Brake Bleeder Screw?

http://repairhelpcenter.blogspot.com/2011/12/what-is-brake-bleeder-screw.html

How to replace car Brake Cable?

http://repairhelpcenter.blogspot.com/2011/12/how-to-replace-car-brake-cable.html

How to Replace Brake Disc?

http://repairhelpcenter.blogspot.com/2011/12/how-to-replace-brake-disc.html

ABS motor keeps running?

http://schematicsdiagram.blogspot.com/2012/01/abs-motor-keeps-running.html

Anti-lock brake light stays on all the time?

http://technoanswers.blogspot.com/2012/01/anti-lock-brake-light-stays-on-all-time.html

Is it necessary to replace Brake caliper while replacing rotors and brake pads?

http://repairhelpcenter.blogspot.com/2012/01/is-it-necessary-to-replace-brake.html

Emergency brake Adjustment for Hyundai Tiburon?

http://schematicsdiagram.blogspot.com/2012/01/emergency-brake-adjustment-for-hyundai.html

How does Brake Backing Plate works?

http://repairhelpcenter.blogspot.in/2012/02/how-does-brake-backing-plate-works.html

How to replace control panel on Audi A4 models?

How to inspect, service and replace brake shoe liner?

How to inspect brake drums?

How to replace Brake light switch on Chevrolet Tahoe?

How to replace brake rotors?

Engine accelerates when brake is applied?

http://technoanswers.blogspot.in/2012/02/engine-accelerates-when-brake-is.html

Loss of acceleration?

http://technoanswers.blogspot.in/2012/02/loss-of-acceleration.html

1996 Chrysler LHS brake light circuit wiring diagram?

http://technoanswers.blogspot.in/2012/02/1996-chrysler-lhs-brake-light-circuit.html

How to replace rear brake pads on 2002 Lincoln continental?

http://technoanswers.blogspot.in/2012/02/how-to-replace-rear-brake-pads-on-2002.html

Brake pedal firm when engine not running goes to floor after engine starts?

http://technoanswers.blogspot.in/2012/02/brake-pedal-firm-when-engine-not.html

How to replace rear Brake lights on 2004 Toyota RAV4?

http://schematicsdiagram.blogspot.in/2012/02/how-to-replace-rear-brake-lights-on.html

Brake drag from wheel area while driving?

http://schematicsdiagram.blogspot.in/2012/02/brake-drag-from-wheel-area-while.html

 Brake pedal Pulsating?

pulsating.htmlhttp://schematicsdiagram.blogspot.in/2012/03/brake-pedal-pulsating.html

No comments:

Post a Comment