Thursday, March 15, 2012

How to replace Blend Door Actuator On Ford Mustang?

Blend Door Actuator Removal & Installation Details are as follows:---


Temperature Blend Door Actuator



Specific to:
Ford Mustang 2009-2010
  1. Lower the glove compartment.
  2. Disconnect the temperature blend door actuator electrical connector.
  3. Remove the 2 temperature blend door actuator screws.
  4. Remove the temperature blend door actuator.
  5. To install, reverse the removal procedure.

    image
    Fig. Temperature blend door actuator

Temperature Blend Door Actuator-LH



Specific to:
Ford Mustang 2010

NOTE
The LH temperature blend door actuator can be accessed from below the LH side of the instrument panel to the right of the accelerator pedal.

  1. Disconnect the LH temperature blend door actuator electrical connector.
  2. Remove the 2 LH temperature blend door actuator screws.
  3. Remove the LH temperature blend door actuator.

    Click image to see an enlarged view
    Fig. Removing and installing the LH temperature blend door actuator-2010 models
  4. To install, reverse the removal procedure.
    NOTE
    The purpose of the module actuator position calibration is to allow the HVAC module to reinitialize and calibrate the actuator stop points. To carry out calibration, carry out the following steps.
  5. Remove Smart Junction Box (SJB) fuse 15 for at least one minute.
    NOTE
    When the ignition switch is switched to the ON position, the HVAC module will initialize and calibrate the actuators. Calibration of the actuators will take approximately 30 seconds.
  6. Reinstall SJB fuse 15. Turn the ignition switch to the ON position and wait 30 seconds before verifying correct LH temperature blend door actuator operation.

Temperature Blend Door Actuator-RH Dual Zone EATC



Specific to:
Ford Mustang 2010
  1. Remove the blower motor.
  2. Remove the 4 glove compartment screws and remove the glove compartment.
  3. Remove the 2 RH temperature blend door actuator screws.
  4. Reposition the RH temperature blend door actuator and disconnect the RH temperature blend door actuator electrical connector.
  5. Remove the RH temperature blend door actuator.

    Click image to see an enlarged view
    Fig. Removing and installing the RH temperature blend door actuator (dual zone EATC)
To install:
  1. To install, reverse the removal procedure.
    NOTE
    The purpose of the module actuator position calibration is to allow the HVAC module to reinitialize and calibrate the actuator stop points. To carry out calibration, carry out the following steps.
  2. Remove Smart Junction Box (SJB) fuse 15 for at least one minute.
    NOTE
    When the ignition switch is switched to the ON position, the HVAC module will initialize and calibrate the actuators. Calibration of the actuators will take approximately 30 seconds.
  3. Reinstall SJB fuse 15. Turn the ignition switch to the ON position and wait 30 seconds before verifying correct RH temperature blend door actuator operation.

Vacuum Control Motor-Air Inlet Duct Door



Specific to:
Ford Mustang 2009-2010
  1. Lower the glove compartment.
  2. Disconnect the air inlet mode door actuator electrical connector.
  3. Remove the 2 air inlet mode door actuator screws.
  4. Remove the air inlet mode door actuator.

    Click image to see an enlarged view
    Fig. Vacuum control motor-air inlet duct door
To install:
  1. Installation is the reverse the removal procedure.

These details will help.
Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html


No comments:

Post a Comment