Friday, March 16, 2012

How To Replace Blend Door Actuator On Ford Ranger?

The Blend Door Actuator Replacing details are as follows:---

Removal & Installation Procedure is Mentioned Below:--


  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Disarm the air bag system.
  3. Disconnect the negative battery cable.
  4. Open the glove compartment to access the passenger air bag module bolts. 

    image
    Fig. Passenger air bag module view
  5. Disconnect the passenger air bag module electrical connector
  6. Remove the two passenger air bag retaining bolts.
  7. Disconnect the passenger air bag module electrical connector.
  8. Placing one hand in the glove compartment, push the passenger air bag module out and remove it.
    WARNING
    Do not handle the passenger air bag module by grabbing the edges of the deployment doors.
  9. Remove the defroster opening grill. 

    image
    Fig. Defroster grill view
  10. Detach and position the RH demister hose aside.
  11. On vehicles with anti-theft/keyless entry, remove the screws and position the anti-theft/keyless entry module aside.
  12. Working through the opening near the RH defroster nozzle, remove the screw.
  13. Disconnect the electrical connector.
  14. Remove the screws and the temperature blend door actuator.
  15. To install, reverse the removal procedure. Tighten the air bag module bolts to 71 inch lbs. (8 Nm). 

    image
    Fig. Temperature blend door actuator view



These details will help.
Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html



No comments:

Post a Comment