Friday, March 16, 2012

How to replace Supercharger On Ford Mustang?

The details to replace Ford Mustang Supercharger are as follows:---


Supercharger
REMOVAL & INSTALLATION Procedure is mentioned below:--



  1. Release the fuel system pressure.
  2. Disconnect the battery ground cable.
  3. Remove the 4 nuts and the strut tower cross brace.
  4. Rotate the drive belt tensioner clockwise and detach the drive belt from the Supercharger (SC) pulley. 

    image
    Fig. Detaching the drive belt from the supercharger pulley


    image
    Fig. Removing and installing the supercharger
To install:

NOTE
Install a new gasket.

  1. Position the SC gasket on the lower intake manifold dowels.
  2. Position the SC and install the bolts. Tighten the bolts in the sequence shown in 2 stages:
    1. Stage 1: Tighten to 44 inch lbs. (5 Nm).
    2. Stage 2: Tighten to 18 ft. lbs. (25 Nm). 

      image
      Fig. Identifying the SC bolt installation sequence
  3. Connect the SC bubbler hose and the SC bypass vacuum actuator vacuum connector.
  4. Install the fuel rail.
  5. Install the EGR system module.
  6. Rotate the drive belt tensioner clockwise and attach the drive belt to the SC pulley.
  7. Install the strut tower cross brace and the 4 nuts. Tighten to 26 ft. lbs. (35 Nm).
  8. Connect the battery ground cable.


These details will help.
Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html


No comments:

Post a Comment